Wiring Help, 2 Amps, New Install, Newbi

[opfreak 10+ year member]

Ok, I trtied searching, but i can't seem to find what i need. Or at least some thing that fits perfect.

I will be getting a phoenix gold setup, (1) xenon 400.1 mono block, (1) xenon 100.4 4 channel. New components will be going in the front, (not sure what yet). and the old kenwood 3 ways will be rear fill. sub is a mb quart 10" pwe 254 (dual coil 2ohm coils, will wire in serises to make it easy? on the amp so it runs at 4 ohms.

doing some math seems like i would need about a 100 amp main fuse on 4 gage wire? then a distro block, with a 60 and a 50 amp fuse on the lines to the amps, (60 to 4 channel, 50 to mono).

I was hoping to find this in a nice kit to get it all in one piece but cannot seem to find anything close.

what are good pieces to use for this set up?

am i on the right track.

also where to purchase this stuff?

car is a 2 door pontiac sunfire 2001.

Click to read more...

 

[iceteebone 5,000+ posts]

imo i would run 1/0 guage to the trunk. always good too have in case of future upgrades. 100 amp anl fuse then under the hood. wire that too a fused distro block with 2 60 amp agu fuses then wire your 2 amps. wire can be found cheap at http://www.weldingsupply.com and the accessories can be found at http://www.knukonceptz.com