wiring 4 Re 8's

[geonfreaq 10+ year member]

I made a thread about this before but it never got answered. I am going to wire 4 Re 8's to my amp... here are the specs.

RMS Power measured at 12.5 Volts DC:

150 Watts x 2 into a 4 Ohm load with less than 0.05% THD+N

300 Watts x 2 into a 2 Ohm load with less than 0.1% THD+N

600 Watts bridged into a 4 Ohm load with less than 0.1% THD+N

Dynamic Power (IHF-202 Std) measured at 14.4 Volts DC

200 Watts x 2 into a 4 Ohm load

375 Watts x 2 into a 2 Ohm load

750 Watts bridged into a 4 Ohm load

I know I should wire 2 subs per channel but how should I wire em? If somone has a diagram that could show me the best way to wire them could you let me know. I dont want to over power em or screw my amp up. //content.invisioncic.com/y282845/emoticons/wave.gif.002382ce7d7c19757ab945cc69819de1.gif

Would this be the best way?(2 per channel)

Click to read more...

 

[ANeonRider 10+ year member]

Best is to run each subs voice coils in series, then each sub in parallel. 2/channel.

Each sub would then be receiving 100W RMS @ 14.4V.