Wiring 1 set of comps with 4 channel amp...

[DukeNut 10+ year member]

so i'd hook them up using the 2 front channels of your amp.

 

[OmegaBunny 10+ year member]

Well I was wanting more than 75 so was going to set gains foe 130-150

 

[DukeNut 10+ year member]

if you want to push 300rms keep your gains low. do you have a link to the manual? ive searched all over and had no luck:-( or even a pic of amp?

 

[OmegaBunny 10+ year member]

Gain would need to be set @ 24.94v for 150w. I have both the manual and pics.

 

[DukeNut 10+ year member]

channel 1 + to left speaker xover input +. channel 2 - to left speaker xover input -. then channel 3 + to right speaker xover input + and channel 4 - to right speaker xover input -. then wire each xover out to the appropriate sides mid and tweet. you will need to use a y adapter on your rcas. hu's front left rca split via Y to channel 1 and 2 and front right rca split via Y to channel 3 and 4. should be all you need

 

[OmegaBunny 10+ year member]

So wire it passive but at bridge for 300w then set gains for say 150 because I doubt the amp does rated. Correct.

 

[Phoenix Risen 10+ year member]

that should do it

 

[OmegaBunny 10+ year member]

Sounds good! Thanks for the help. That's what I was going to do in the first place but I made it more complicated the more I thought about it. I have to remember K.I.S.S. (keep it simple stupid)

 

[Phoenix Risen 10+ year member]

its very easy to forget that rule

 

[DukeNut 10+ year member]

omega, let us know how it turns out.