Will this sub box design work for a W7?

[dross93ranger 10+ year member]

I am going to be looking to get a box built soon. I have been looking for shallow 8's because I was going to downsize my system to fit a baby stroller. I now am reconsidering because I think I can get a new box built that will give me back my room.

I have a JL 8W7 sitting it the garage and am considering running it ported, 1 cu foot, tuned to 34hz as JL recommends.

EDITED:

I have up to 40" of width to deal with, 10-12" bottom depth, Seat back is 65*(found with an angle finder) so that should determine the top depth, and 10-12" of height. The back of the sub box will be slanted and sit against the seat and the flat front with house the W7. would I be able to work with this/will the sub fit? It's mounting depth is 6.83

And finally, if it will work, would someone be willing to design it and build it? I have amps up for trade for 8's and could just sell the 4-channel to fund the box and use the mono to run this sub.

Click to read more...

 

[Motokid 10+ year member]

[quote name='dross93ranger']I am going to be looking to get a box built soon. I have been looking for shallow 8's because I was going to downsize my system to fit a baby stroller. I now am reconsidering because I think I can get a new box built that will give me back my room.

I have a JL 8W7 sitting it the garage and am considering running it ported, 1 cu foot, tuned to 34hz as JL recommends.

I have 40" of width to deal with, 10" bottom depth, 8" top depth, and 10" of height. The back of the sub box will be slanted and sit against the seat and the flat front with house the W7. would I be able to work with this/will the sub fit? It's mounting depth is 6.83

And finally, if it will work, would someone be willing to design it and build it? I have amps up for trade for 8's and could just sell the 4-channel to fund the box and use the mono to run this sub.[/QUOTE]

Message @mobeious; . There are tons of guys on the forum who will sell you just box designs, and some will build them too as well.

 

[CSCStang]

@Boomsday ;

 

[dross93ranger 10+ year member]

I just edited the original post after drawing it out on paper and realizing that there was no way in hell that would work easily. Sorry for the confusion, I'm no enclosure designer. This is going in a 2004 Ford Focus btw, I downgraded to an E8 in a factory box and am not satisfied and want my W7 installed again //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif