What's your favorite fuse holder?

[Enellz 10+ year member]

I brought a 0g fuse holder way back and it's always given me problems. Need a new one and I want one that won't sh!t on me in two months. Discuss.

Click to read more...

 

[SethPhillips 5,000+ posts]

Stinger.

ALLL DAAAY.

 

[bhsdriller 10+ year member]

knukonceptz

 

[Brian_smith06 10+ year member]

Stinger.
ALLL DAAAY.

this

some tsunami are nice too

 

[Enellz 10+ year member]

I need one with good depth to put the 0g in, alot I seen recently don't have a hold with the depth long enough and since I don't have hyperflex, or a super flexible power wire in general it can't do

 

[bhsdriller 10+ year member]

http://knukonceptz.com/productDetail.cfm?prodID=FH-20

I have 4 in my truck and they work great, Have never given me a problem

 

[SethPhillips 5,000+ posts]

I need one with good depth to put the 0g in, alot I seen recently don't have a hold with the depth long enough and since I don't have hyperflex, or a super flexible power wire in general it can't do

as a installer i have delt with a bunch of bullshit.

to me. Stinger is the way to go.

Tsunami is crap.

Knu never liked them once i got batt terminals and the didnt even fit correctly. bullshit..

Rockford and Kicker make some nice fuse holder's

 

[scoob8000 10+ year member]

I like the knu konfused fittings.. Instead of a little set screw to hold the wire, you feed it into the fitting, fold it over the lip and crank the fitting down. Lot more surface area for holding strength and conductivity.

 

[Enellz 10+ year member]

I like the knu konfused fittings.. Instead of a little set screw to hold the wire, you feed it into the fitting, fold it over the lip and crank the fitting down. Lot more surface area for holding strength and conductivity.

These sound different. I just don't want BS fuse holders.

 

[Stephen_c 10+ year member]

kicker

 

[99grandprixGT 5,000+ posts]

i like my knu have 3 of them work good

 

[scoob8000 10+ year member]

Here's a link to the one I was thinking of. I don't have it, but I have distro blocks using those same fittings. It's a little more of a pain to connect everything up, but it's not gonna go anywhere once ya do..

http://www.knukonceptz.com/productDetail.cfm?prodID=KNI-11

 

[Lakota 5,000+ posts]

We like to make our own:

 

[IDSkoT 5,000+ posts]

This.

When I upgrade to 0 AWG, I plan on getting 2 strips of metal, probably 1/4" or 1/8" thick, 2-4" long, and just using that as an ANL fuse holder.

Can I get some info on the math behind that? Do the fuses combined just have to = the total maximum current flow?

 

[Lakota 5,000+ posts]

Just throw enough fuses in there that won't pop for daily driving.

We were running all 5A fuses, but they were more equivalent to about 30A.