Whats the 6" aero cutout size?

[duece212 5,000+ posts]

I'm probably dumb and missing it on the psp site somewhere, but does anybody know the cutout diameter for a 6" psp aero?

Click to read more...

 

[Rashaddd 5,000+ posts]

8.5"

 

[duece212 5,000+ posts]

8.5"

word, thanks man, you're not too bad for a terrorist //content.invisioncic.com/y282845/emoticons/thumbsup.gif.3287b36ca96645a13a43aff531f37f02.gif

 

[roarzorz 10+ year member]

I'm 100% positive it's 8 3/8".

 

[Rashaddd 5,000+ posts]

I'm 100% positive it's 8 3/8".

I just measured //content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

flange's are 3/8" on each side, overall width is a 32nd short of 9.25", leaving a 32nd under 8.5"

 

[duece212 5,000+ posts]

Just found out that 8 7/16 makes a nice snug fit, port presses in solid

8 1/2 leaves wiggle room //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

 

[tommyk90 5,000+ posts]

Just found out that 8 7/16 makes a nice snug fit, port presses in solid
8 1/2 leaves wiggle room //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

1/16 of an inch leaves that much wiggle room?

Maybe your cuts ****. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[duece212 5,000+ posts]

1/16 of an inch leaves that much wiggle room?
Maybe your cuts ****. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Cuts were done with a jasper jig so thats not it, maybe I'm just being picky //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

Since the ports don't have much of a lip for mounting its nice to have them snug on the inside collar of the port too. Will probably put a wrap or two of duct tape on the collar of the port to snug it up, ghetto but should take up the little slack there is.

 

[anj46907 10+ year member]

I'm probably dumb and missing it on the psp site somewhere, but does anybody know the cutout diameter for a 6" psp aero?

 

[roarzorz 10+ year member]

Just found out that 8 7/16 makes a nice snug fit, port presses in solid
8 1/2 leaves wiggle room //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

8 3/8" is the perfect size. They fit nice and tight.

 

[Corey69 10+ year member]

If you got a jasper jig why dont you flush mount them, and use hot glue on the inside to keep them in place.