US Amps....

[Myster 10+ year member]

On the US Amps site it lists the I/S 4085 amp at either 125x4 @ 4ohm & 400x1 @ 4ohm bridged..... is that correct or possible to bridge 4 channels to 1?

Click to read more...

 

[azbass 5,000+ posts]

id pm flakko.

 

[alphakenny1 10+ year member]

usamps website is BS. use this site for correct information, http://www.soundsolutionsaudio.com/forum/index.php?showtopic=4414.

 

[Myster 10+ year member]

thanks for clearing that up, that helped a ton!

If I was to wire 2 subs to a 2 channel amp would the following wiring configuration work..

 

[alphakenny1 10+ year member]

depends on the amp and the impedance of the subs.

 

[Myster 10+ year member]

the subs are Elemental Designs Kv.2 w/dual 4ohm voice coils (running two). Recommended power is 200-300w each.

Would it be better to get a 2 channel amp and run each on a seperate channel and wire for 2ohm or bridge it to 1 channel and wire them either 4 or 1ohm?

 

[denim 5,000+ posts]

usamps website is BS. use this site for correct information, http://www.soundsolutionsaudio.com/forum/index.php?showtopic=4414.

//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif