Two much head room ?

rp69
10+ year member

Senior VIP Member
Hello gust wondering if 325rms two set of components is to much power . The components are focal 165krx2 which are 100w rms and are a 2ohm set up . The amp is a ppi power class 650.2 it does 325x2 at 2ohm. It's a very low distortion clean amp with good dampening factor.

 
i would be careful setting those up on 300w each rms, they may take it but you're going to need to watch your high pass filter and likely set it pretty high 120-150hz. if you hear any distortion turn it down until it goes away

 
I am still learning so if what I am saying sounds crazy is because herd the info from other people. Will it be OK for the crossover net and will the tweeters be able to handle it .will I have floor noise issues

 
To be helpful, not to be rude:

damp·ing

ˈdampiNG/Submit

noun

1. technical

a decrease in the amplitude of an oscillation as a result of energy being drained from the system to overcome frictional or other resistive forces.

damp·en

ˈdampən

verb

gerund or present participle: dampening

1.make slightly wet.

 
To be helpful, not to be rude:

damp·ing

ˈdampiNG

noun

1. technical

a decrease in the amplitude of an oscillation as a result of energy being drained from the system to overcome frictional or other resistive forces.

damp·en

ˈdampən

verb

gerund or present participle: dampening

1.make slightly wet.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

rp69

10+ year member
Senior VIP Member
Thread starter
rp69
Joined
Location
calgary alberta
Start date
Participants
Who Replied
Replies
10
Views
735
Last reply date
Last reply from
n2audio
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top