two channel amp

  • 1
    Participant count
  • Participant list

mrjarrett

Junior Member
I need help. I have a kenwood h.u. with front, rear, and sub outs. I want to wire my mids and highs But dont have a 4 channel amp. I want to do it using this unit and a memphis 16 x03 xover. The mid and high amp will be a memphis pr200. Polk audio fronts and rears. Can anyone help in configuration?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
111
Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
542
It is Opel (Vauxhall) Astra J 2011 model, I change the HU to Kirinavi 10 inch screen. The factory speakers are Infinity and would have come with a...
3
713
Okay, I'll bite. If you're going to get rear speakers, get the same ones (model type, doesn't have to be the same size) that you have up front...
1
945
I would keep the amp you have and keep the components. Place the components in some universal door pods, and look at getting a powered SAS 8"...
13
1K

About this thread

mrjarrett

Junior Member
Thread starter
mrjarrett
Joined
Location
Macon, Georgia
Start date
Participants
Who Replied
Replies
0
Views
347
Last reply date
Last reply from
mrjarrett
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0
1000007974.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top