twelve two ohm voice coils?

[Death By Bass 10+ year member]

how would you wire them?

they are to be run off a DD Z1, which will give around 3000watts rms into 1 ohm.

Im looking to run it at around 1 ohm daily, with the ability to fairly easily load it down lower for burps.

any ideas? lol

1.5 ohms is fairly easily achievable, and Im happy with that, but what would YOU do?

Click to read more...

 

[btlking 10+ year member]

are these single or dual 2?

 

[9512ds 5,000+ posts]

are they 12 woofers, or 6 dual 2 woofers?

 

[Death By Bass 10+ year member]

are these single or dual 2?

its six dual coil subs, yes.

edit: really makes no difference though.

 

[btlking 10+ year member]

id wire them down below one ohm the z1 can handle it

 

[btlking 10+ year member]

well if you need the power

 

[Death By Bass 10+ year member]

id wire them down below one ohm the z1 can handle it

the idea was to wire them at around 1 ohm for daily, and lower for burps in competitions, which I did say in the first post...

 

[smd4life 5,000+ posts]

the idea was to wire them at around 1 ohm for daily, and lower for burps in competitions, which I did say in the first post...

not before you edited it //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

 

[btlking 10+ year member]

so what are you exactly asking then?

 

[Death By Bass 10+ year member]

not before you edited it //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

I didnt edit the first post //content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif

Im asking, how would you wire them daily?

what in series with what, in parallel with what, to get what?

apparently the Z1 will give 3000watts into around 2.5 ohms...

http://ampguts.realmofexcursion.com/DD_Z1/

so, maybe I wont even bother loading it down to 1 ohm daily... 3000watts is all I need... lol

 

[btlking 10+ year member]

http://www.rockfordfosgate.com/rftech/woofer_wizard.asp?submitted=true&woofer_qty=3&woofer_imp=3

bottom one then wire together for 1.34 or so just set the gaing according

 

[Death By Bass 10+ year member]

http://www.rockfordfosgate.com/rftech/woofer_wizard.asp?submitted=true&woofer_qty=3&woofer_imp=3
bottom one then wire together for 1.34 or so just set the gaing according

you mean 1.5ohm

 

[Death By Bass 10+ year member]

perhaps I should wire each set of three woofers at 1.34ohms, connect them in series for daily driving (2.7 ohms) or parallel for competitions (0.7 ohms)

//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

the amplifier will apparently give the amount of power Im wanting into 2.5 ohms, and its a lot easier to change the wiring config around if I wire it as mentioned above.

 

[its_bacon12 10+ year member]

nm