Tweets to match with RE Comps

[abcheng 10+ year member]

I've had my RE Comps installed for a while but the tweets on them are too harsh for my taste. What tweets would you guys recommend to go with the RE comps? Should I get a pair of CDT tweets ?

Click to read more...

 

[Tempe 10+ year member]

Dayton silk 1-1/8" tweet is really smooth if you can fit it.....

Tempe

 

[abcheng 10+ year member]

which one on PE's webpage? Also, is the crossover w/ the RE comps fine for it? How would I go about mounting it?

 

[SSS 18734 5,000+ posts]

a user here on the forums replaced his with Aura tweeters and seemed pretty happy with them.

Personally, I think the RE tweets are just fine so I havn't bothered replacing them.

 

[Tempe 10+ year member]

which one on PE's webpage? Also, is the crossover w/ the RE comps fine for it? How would I go about mounting it?

http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=275-070

This one is what I had in mind. No the 8 ohm impedence would give you a higher crossover point IIRC.

http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=275-035

This might work, but I am concerned about its ability to play down to 2khz....

Tempe

 

[abcheng 10+ year member]

hmm alright. Would there be a huge noticeable diff since the impedance is raised from 4 to 8 ohms? How would I go about mounting this thing?

 

[Tempe 10+ year member]

There would be an audible gap. I would not change the impedence. You really should stick with a 4 ohm tweeter.

 

[abcheng 10+ year member]

What about CDT Audio Tweets such as their Image Enhancement sets?

 

[Logikalliquid 10+ year member]

http://www.madisound.com/cgi-bin/index.cgi?cart_id=7372174.28173&pid=850

What about these? Isn't the tweeter the Adire Koda components tweeter was based off of?