to those of you wanting better gas mileage

Actually it works, however its has been known that using acetone in a fuel injected vehicle will harm your injectors by thinning the viscosity of the fuel. Your injectors use the oil in the fuel to lubricate internal moving parts. You can combat this by adding a capful of ATF in the mix. It has been tried and works great.

There is always a disclaimer due to the fact that everyone thinks that well if a little is good, then a lot must be better. Also note that if your mixture is off, you could do serious harm to your engine and other parts of the fuel system.

 
old news.. and yes it works sorta... works best with bigger engines... ur 4 banger isn't gonna do squat //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 
ive been reading around and it seems that itll take a couple tanks of gas for it to get to its full potential and it wont mess up your paint because of the fact that it dries up so quickly. and it wont mess up the plastic because the gas would have already messed it up. i think that i might try it out.who knows whats gonna happen untill you try it yourself. right?

 
I think i will do alittle more reading on this. I will most likely try it.

the amount of Acetone you are adding in relative to the amount of gasoline, the acetone is so diluted it shouldnt cause any damage to any parts

I drive 50+ miles to work so if it works then great

 
Activity
No one is currently typing a reply...

About this thread

regal8r

5,000+ posts
I <3 my CRX
Thread starter
regal8r
Joined
Location
Lincoln, NE
Start date
Participants
Who Replied
Replies
16
Views
451
Last reply date
Last reply from
pilyin
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top