Time correction help on CDA-9887

[ramos 5,000+ posts]

So if I'm running the components actively, I measure the distance of the left tweeter to my ear, right tweeter to my ear, take the difference, convert it to meters then ms and add that one to whichever is closer? And same thing with the mids? Thanks for the help!
Mike

yes but don't worry about converting it from inches . After reading the manual , you just need to know the differences in inches to enter them. But just delay the closest . A lot of times though, you don't need to delay the tweets, or very minimal delay at least . Just use the measurement to get a ballpark starting point. Then listen and find what's sounds best to you. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[MBrock4u 10+ year member]

What about your sub setting? Where would this be set at?

 

[mikey7182 10+ year member]

I've never delayed my sub before... I think that would actually make it worse as the sub is usually the farthest away. You'd almost want to delay everything else to be in time with the sub. Now that would be some tricky math! //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[jblayz1 10+ year member]

yes but don't worry about converting it from inches . After reading the manual , you just need to know the differences in inches to enter them. But just delay the closest . A lot of times though, you don't need to delay the tweets, or very minimal delay at least . Just use the measurement to get a ballpark starting point. Then listen and find what's sounds best to you. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

*edit*