haha i been workin a lot, but here we go
Sorry bout the delay on that
^^That one is the last i will show of the cutlines for the bottom
lawl
Once again, the original bottom piece.....t is the bottom of the box, but is no longer the way that the box is secured to the car. It was originally planned so i could maximize airspace, but lookng at it, its just not pratical.
That is the bottom....it covers the bottom, all the way to the back of the trunk,. to the front of the back seat. This is what you would call, the dance floor. It is clamped down in the front. heavy amount of glue in the front, wood glue that is
Clamped down in the front, left it clamped for a day or so. Tried pulling that piece up from the back side.....its not happenin at all
had to cut the back corners out to get it to fit in the trunk.
Pic of the bottom....its actually 5 layers Thick, with mounting hardware in each corner
Reason for all taht is because the area where the seats are, is lower than the area where the trunk floor is, and it needed to all be nice an even, or the wall would have a little lean in it, whicl is really bad, and un necessary....Thing has to be solid, or it can move while you are driving....which i can imagine, is truly horrible.
:
