Sundown Amp Clamp Tests

[sundownz Pro Seller]

I did this a while back so some new stuff is not in there obviously... but a good reference none-the-less.

Once the new SAZ line is all done I will go back and do something like this again.

----------

I am going to go through and drop the SAZ-1000D, SAE-1200D, SAZ-1500D, SAZ-2000D, SAZ-3000D, and SAZ-3500D in the Jeep and do a power clamp test so we have a rough and UNIFORM comparison between the amps in the same setup.

Test Frequency - 50 Hz

Test Load - 4x SA-12s all in parallel for 0.4375 DCR (1/2 nominal)

Test Electrical - 6x Stinger SPV-70 + 225-Amp Alternator (vehicle only at idle)

Amp gain set to 1/2 - Head Unit Sub Control 10/10 - Head Unit Volume 50/50

Setting gain to half on each amp is, of course, not an exact match... but for the sake of roughly comparing the amps I think it serves the purpose.

---------------

SAZ-1000D:

POWER : 1040 Watts

AMP VOLTAGE (measured) : 37.2 V

AMP CURRENT (calculated) : 27.95 A

ACTUAL IMPEDANCE (calculated) : 1.33 ohms

SUPPLY VOLTAGE : 13.15 V

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2498.MOV

* Power Clamp

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2499.MOV

* Voltage Measurement

---------------

SAE-1200D:

POWER : 1770 Watts

AMP VOLTAGE (measured) : DID NOT MEASURE

AMP CURRENT (calculated) : DID NOT MEASURE

ACTUAL IMPEDANCE (calculated) : DID NOT MEASURE

SUPPLY VOLTAGE : 12.65 V

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2513.MOV

* Power Clamp

DID NOT MEASURE

* Voltage Measurement

** FUSES BLEW - DID NOT CONTINUE TO MEASURE VOLTAGE

---------------

SAZ-1500D:

POWER : 1970 Watts

AMP VOLTAGE (measured) : 49.25 V

AMP CURRENT (calculated) : 40 A

ACTUAL IMPEDANCE (calculated) : 1.23 ohms

SUPPLY VOLTAGE : 12.85 V

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2493.MOV

* Power Clamp

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2494.MOV

* Voltage Measurement

---------------

SAZ-2000D:

POWER : 2440 Watts

AMP VOLTAGE (measured) : 56.18 V

AMP CURRENT (calculated) : 43.43 A

ACTUAL IMPEDANCE (calculated) : 1.29 ohms

SUPPLY VOLTAGE : 12.5 V

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2503.MOV

* Power Clamp

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2504.MOV

* Voltage Measurement

---------------

SAZ-3000D:

POWER : 3280 Watts

AMP VOLTAGE (measured) : 61.28 V

AMP CURRENT (calculated) : 53.52 A

ACTUAL IMPEDANCE (calculated) : 1.14 ohms

SUPPLY VOLTAGE : 12.1 V

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2506.MOV

* Power Clamp

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2507.MOV

* Voltage Measurement

---------------

SAZ-3500D:

POWER : 3660 Watts

AMP VOLTAGE (measured) : 65.84 V

AMP CURRENT (calculated) : 55.58 A

ACTUAL IMPEDANCE (calculated) : 1.18 ohms

SUPPLY VOLTAGE : 11.9 V

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2510.MOV

* Power Clamp

http://www.sundownaudio.com/misc/_AMP_POWE...0D/CIMG2511.MOV

* Voltage Measurement

---------------

SAZ-4500D:

* SAZ-4500D in prototype case - this is NOT the production case.

POWER : 4870 Watts

AMP VOLTAGE (measured) : 76.0 V

AMP CURRENT (calculated) : 64.08 A

ACTUAL IMPEDANCE (calculated) : 1.18 ohms

SUPPLY VOLTAGE : 12.25 V ***

http://www.sundownaudio.com/misc/_AMP_POWER/4500D/CIMG2529.MOV

* Power Clamp

http://www.sundownaudio.com/misc/_AMP_POWER/4500D/CIMG2530.MOV

* Voltage Measurement

*** - Measured different day from other amps (8-4-09), batteries had full charge so sustained less voltage drop.

---------------

These are not necessarily definitive tests on the amps.

 

All applications are different and I could have probably squeezed more out of an amp here or there... but for the sake of this test I just set the gain knobs to physically 1/2 way up.

 

Just a rough guide to show what the amps can do!

 

I may go back one day and do an SPL comparison as well -- as we have seen up to 1 dB increase from the 3000D to the 3500D even though the power test doesn't seem to indicate as much. With the SPL portion I would sit down and tweak knobs until I got maximum SPL per amp.

I tested amps from smallest to largest (for the most part except 1200D was tested last) -- so the batteries did not have a complete full charge by the time I got to the big amps, just a few minutes of alternator charge time... that just means the bigger amps will produce more than posted if I had a complete charge. This was mentioned in my initial post so I thought I would post it here as well.

Click to read more...

 

[LosIsATool 5,000+ posts]

Why discontinue the 4500? Just when I can run it.

 

[ahole-ic]

Why discontinue the 4500? Just when I can run it.

I'm sure he took that under heavy consideration before deciding brah.

 

[slim2fattycake 10+ year member]

So where's the oscope?

 

[05trailblazer 10+ year member]

sleeping from al that power