Subwoofer help!!

  • 1
    Participant count
  • Participant list

DJSlowfets

Senior VIP Member
476
4
CA
Hi guys im getting a VERY cheap sub system and im sticking to it i only make so much money at 16..

well im getting, MTX Audio Terminator Series TNE212D 1,200-Watt Dual 12-Inch Sub Enclosure:Amazon:Car Electronics

It it 200 watts rms MAX for both subs so i need a 400 watt amp at 2 ohm and i am finding hel* of a time finding a quality amp thats 400 rms at 2 ohm there is a pioneer model im looking at but hardly anywhere to buy so this brings me to my question.. its 400 watt rms MAX can i run 500 watts and not blow them or get them hot? ?? Will they be fine for years if i run at 500? Please help thanks! :)

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

In a case like In a case like yours I would rather recommend tactile transducers. They are like woofers without the cone section that are...
7
995
So the car audio shop I took it to just claimed "bad wiring" and now it all works. Not really sure what that means but case closed! thanks...
14
1K
You can't really set it to a specific wattage. What head unit do you have? Find out the pre-amp RCA voltage. Most amp gain knobs are based off of...
7
1K
problem was the LOC burnt out when I had touched cables. got a new LOC and now all is working. have to get the gain right, lights flickering with...
11
2K

About this thread

DJSlowfets

Senior VIP Member
Thread starter
DJSlowfets
Joined
Location
CA
Start date
Participants
Who Replied
Replies
0
Views
539
Last reply date
Last reply from
DJSlowfets
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top