Subs not hitting lowes?

To test if they are out of phase of not

Get a 9 volt battery or something like that and touch the + wires and - to the battery. If they both move out they are in phase, if one goes in and other out they are out of phase. If one ***** in and one pushes out switch the wires around

 
sounds more like a wiring problem.....

os w6's sounded good sealed or ported!! squeezed in 2 15w6s in a nissan 240sx i had... it ****** the air right out of you and made your ears tingle n hurt... not bad for a sealed set up!!

 
So I compared a bag of packing penuts. No way this box is even close to 2.5. Maybe 1.8 so ill need alot of polyfill for it our make a new box. Any one have a. website that calculate how much poly and tube length I would need

 
psp-inc.com to calculate the port length

You going to have an external port? If you put it on the inside of the box it would make the volume even smaller than it is now

You would have to recalculate with the displacement of the port inside the box

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

kgcolbyIII

10+ year member
Senior VIP Member
Thread starter
kgcolbyIII
Joined
Location
oceanside, ca
Start date
Participants
Who Replied
Replies
28
Views
6,107
Last reply date
Last reply from
kgcolbyIII
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top