subs making burping noise

Did you take the sub out and look at it? Personally, I've seen burping in 2 scenarios.. clipping/bottoming out, or what sounds like burping, when a tinsel comes loose and slaps against the cone.

 
nah they're brand new..

so i'm sure its clipping.. i guess i'm underpowering them...

so what could i do? jus turn the gains down and make sure they don't clip?

 
are you sure you're not overpoering them? The same thing happened to me. It's hard to believe you're underpowering them if it only happens when the gain is all the way up. Check and make sure your running enough power.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Looks like half a dozen other makes/models on the market, rebranded . The shallow mounts look like they’re made by Pioneer but what the hay, one...
8
1K
They're rated for 250wrms, so you were overpowering them, especially the poor 10s. XBL subs sound really clean at their limits due to the flat BL...
10
351
These are also very good drivers, some of the best bang for the busk on shallow mounts. DD Audio SL610-D2 10"...
5
471
Well, get Two then and try to share for peeks sake!! :poop: :ROFLMAO::ROFLMAO::ROFLMAO:
16
1K

About this thread

deeza

Junior Member
Thread starter
deeza
Joined
Location
t dot
Start date
Participants
Who Replied
Replies
9
Views
723
Last reply date
Last reply from
rocca_dogg
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top