I have a 10" Oz Matrix Elite 4ohm DVC sub and a PG Tantrum 300.2. Can I wire the sub into a 2 ohm load and run my PG amp in bridged mono or would that be to much of a load for that amp? Also, I have an extra PG Tantrum 300.2. Is it possible to use the pair and have each amp run a voice coil on the sub? If so, what's the best way to wire each amp to the sub?
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
One or two, they are still subwoofer outs and are mono summed signals from both left and right. Even the 2 RCA subwoofer pre-outs on the 2nd one...
- Started by kanihoncho
- Speakers
Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
- Started by Aaron Johnson
- General Car Audio
Hahaha his brother got some from a friend. American bass amp and some alpine s 12in subs. From a buddy of his now Eastons chomping at the bit...
- Started by Booger68
- General Car Audio
Hello all. Used to come on these forum quite a bit. I used to compete in IASCA MECA etc. and placed 1st 2x with this setup. Anyway this is my baby...
- Started by strkrfan13
- Car Audio Classifieds
About this thread
New threads
-
Low volume ONLY while drivingI have a Skar svr-10 inch sub and a skar rp-800.1d 800w rms...
- Started by Maddoxp07
- Replies: 0
-
WANTED Down4Sound MM1004 GrayWould like a gray D4S MM1004 to match my other gray MM1004...
- Started by kenvicta
- Replies: 0
-
What's this worth?Going to go on a different direction when I get my new...- Started by chillin
- Replies: 4
-
-
Multi speakersHello all, need some wiring advise for some speakers. I have...- Started by 07FLSTC
- Replies: 2