Strapped Crunchgp3k pros (amp fried)

jdmferio13
10+ year member

feayfm
Well finally strapped the crunch's today.Dont really have enough electrical for .5 ohm a piece.So I decided to run them strapped at 4ohms for better efficiency and less voltage drop.So I started by doing everything manual said and ran each coil to each amp like suggested.Started car and everything was good so I slowly turned gain up and played for a couple of min then boom.It made a noise then smoke everywhere.It was so hot the pos and neg terminals to the amp were brite red.Whats funny is when I saw it burn up I shut the car off the good amp and 4ch turned off.The burnt amp stayed on with the car off but why?What did I do wrong?

 
Well if the pos and neg got red hot then the amp is a dead short and that's how car fires can start, the fuse to the amp didn't blow?

If you're going for efficiency then you should have used just one amp. Oh well shit happens at least you have 3000 watts left.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

jdmferio13

10+ year member
feayfm
Thread starter
jdmferio13
Joined
Location
Central,PA
Start date
Participants
Who Replied
Replies
11
Views
755
Last reply date
Last reply from
Twisted_0912
IMG_20260515_202650612_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0
IMG_20260515_202732887_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0

New threads

Top