SQ setup with this amp

[DrunkenDangler 10+ year member]

memphis 16-MC4.75

4ohm 2ohm bridged 4 ohms

75W x 4 115W x 4 N/A 230W x 2

0.10 20Hz - 20kHz 17.20"

Iam wanting to run a small sq set up off this amp give me some ideas and examples on what speakers and subs you would run off this amp. im getting this box for my sub it holds an 8 or 10 inch sub. SQ is really what im shooting for

02-2009 Avalanche/Cadillac Ext.Rear Console Pro Poly Sub Box - Car

Click to read more...

 

[DrunkenDangler 10+ year member]

Anyone?

 

[James Bang 5,000+ posts]

a set of 4 or 2 ohm comps and bridge to channels two a svc 4 ohm sub...ported for efficiency.

 

[DrunkenDangler 10+ year member]

i got 2 sets kappas one being a component set the other being a a set of 3 ways. They both are 2 ohms could i run them with a svc 4 ohm sub with that amp?

 

[gunz4me2 10+ year member]

Yes, you could use either your components or 3 ways with two channels of your amplifier and bridge the other two to your sub.

Also, I hate to break it to you, but your Kappas are NOT true 2 ohm drivers! It was a nice marketing ploy by Harmon International:

Back of the box:

Front of the box:

DCR:

If that was a true 2 ohm driver, I'd expect to see the DCR read in the 1.6 to 1.8 ohm range, not 2.4 ohms!

Finally, for those who wish to give me flack, that DMM measured within .1 ohm of a calibrated Fluke, so I don't want to hear it!

 

[DrunkenDangler 10+ year member]

Those lying **** ******* bastards!