Sound Deadening, Is This Good?

Astyl
10+ year member

Car Audio Enthusiast
Hey guys so i recently purchased 70sqft of Sound Deadening to do my entire trunk with, and this is how i was planning for it to work

I bought 50sqft of Fatmat and 20sqft of eDead v2 ( the Butyl Stuff )

Since FatMat is appariently Asphault Based, i was planning on using it on my Trunk Floor and my Trunk Sides, since that isent a very high load situation, and would be less likely to fall off ( obviously, if its on the floor or mildly sloped sides )

And then use the 20sqft of eDead to do my trunk lid with because its Butyl and probobly wont fall off unless i do something completely wrong

is this a good setup?

 
to answer your question, yes it should stick just fine...I would have just spent a bit of extra and gotten butyl all around. Not only does it stick better, it deadens better too.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Astyl

10+ year member
Car Audio Enthusiast
Thread starter
Astyl
Joined
Location
Bedford, NH
Start date
Participants
Who Replied
Replies
3
Views
522
Last reply date
Last reply from
spoonraker
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top