Stealth_SUX_
Junior Member
Ok i have two solo L5's and a 1200.1 amp, long story short i blew the subs in about 30 min, cause i did full power from the start. luckly mine are lifetime guarenty, so i am getting them replaced tomorrow.
My question is, is the 1200.1 amp too much for it. cause it is rated at 1450 rms on mine and my subs are rated a 600rms each which would be 1200 rms.
if its not too big for it what do i have to do so it wont blow again. i heard i am supposed to alow it to work in for a couple of hours, how long?
And if its not to big will i ever be able to turn the amp all the way up?
thanx for any help
2 solo L5 wired at 1 ohm
single chamber, dual slotted box.
1200.1 with 0 guage wire
My question is, is the 1200.1 amp too much for it. cause it is rated at 1450 rms on mine and my subs are rated a 600rms each which would be 1200 rms.
if its not too big for it what do i have to do so it wont blow again. i heard i am supposed to alow it to work in for a couple of hours, how long?
And if its not to big will i ever be able to turn the amp all the way up?
thanx for any help
2 solo L5 wired at 1 ohm
single chamber, dual slotted box.
1200.1 with 0 guage wire
