Silly question

[BassAddictJ 5,000+ posts]

well im gonna be upgrading to 4 runs of 1/0, 2 pos, 2 neg. curently i have 2 runs. well i noticed one of u current runs is just 0awg and not 1/0awg. I doubt itd make a differance, but i wanted to double check. should i make sure all 4 runs are 1/0 or (making the most sense) will it not really matter?

Click to read more...

 

[TIeclipseMOJO 10+ year member]

0 and 1/0 are the same thing, just two different lables

 

[audiobahnuser18 5,000+ posts]

1/0 and 0 awg are the same just diffrent way's of typing them really.

 

[dvrmstrng 5,000+ posts]

another silly question....why do you have to run neg from the front?

 

[hardhitta47 10+ year member]

He's got another battery (or multiple batteries) in the trunk.

 

[lostdaytomorrow 10+ year member]

He's got another battery (or multiple batteries) in the trunk.

Or his chassis is a bad conductor (multiple weld points).

 

[BassAddictJ 5,000+ posts]

Or his chassis is a bad conductor (multiple weld points).

chasis is a good ground unless you're moving a shit ton of current.

im gonna be moving a shit ton of current //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[ngsm13 5,000+ posts]

**** wasting that much wire.

I grinded done a section on my frame and did triple frame grounds in the front... and then triple frame grounds on the same frame in the rear. Then coated them in underbody coat after torque-ing them down with lock washers.

//content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

nG

 

[lostdaytomorrow 10+ year member]

chasis is a good ground unless you're moving a shit ton of current.


im gonna be moving a shit ton of current //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

I'm assuming you would be moving a lot of current due to the fact you're using 0/1 awg.

We are agreeing.

 

[helotaxi 5,000+ posts]

**** wasting that much wire.
I grinded done a section on my frame and did triple frame grounds in the front... and then triple frame grounds on the same frame in the rear. Then coated them in underbody coat after torque-ing them down with lock washers.

That works great if your vehicle has a frame. Mine doesn't and neither do any other unibodys.

 

[ngsm13 5,000+ posts]

That works great if your vehicle has a frame. Mine doesn't and neither do any other unibodys.

Indeed!

nG