Sealed 12" Recomendations

[530racer 10+ year member]

The sub and port would face up. The depth will be from the floor up and width is from the back of the car to the end of the storage area. Hope this helps.

 

[Buck 5,000+ posts]

Ya, that helps quite a bit.

 

[Buck 5,000+ posts]

Ok, you run into a problem with that. If the face is 14.5 x 13.5, the sub and port will not both fit. Not enough room. What vehicle is this going in?

 

[530racer 10+ year member]

2001 firebird. You can put the port facing the back of the car if that would work.

 

[Buck 5,000+ posts]

Ok man, I actually did a box for a camaro before, you know basically the same car. Where in the car is it going? I had a box where the port fired to the right and it sounded really good. Just a thought.

 

[530racer 10+ year member]

I would like to put it in the t-top storage area so it cant be seen from outside the car.

 

[Buck 5,000+ posts]

Ok I've gotcha. I might have messed up. I think I did. Uh I'm a retard. The face that the sub and port will be on would be 32"x14.5". Ya, that'll fit. :facepalm:

 

[530racer 10+ year member]

Hahaha thanks

 

[Buck 5,000+ posts]

Ok, I've got a simple ported box design you could try for the Fi Q. Now keep in mind there are many other subs that would work in you application, but the Fi Q is good. This design uses all your space. The internal space with be about ~2 cubic feet tuned to 30-31 hz, with 29.25 square inches of port. The only issue with a sub like this is that it likes low tuning, and that generally means a longer port, which means more room taken up by the port, but it'll work.

 

[530racer 10+ year member]

Thank you very much can you pm me the design?

 

[Buck 5,000+ posts]

Ok, will do. Give me a few to draw it up.

 

[530racer 10+ year member]

Ok thanks again

 

[Buck 5,000+ posts]

No problem, you've got a PM.

 

[530racer 10+ year member]

PM sent

 

[Buck 5,000+ posts]

You've got another.