scratchy amp gain

  • 3
    Participant count
  • Participant list
I would try contact cleaner spray (Radio Shack). But you'll have to open the amp up and get the spray inside the gain control to be able to clean it. Sometimes the controls are sealed which makes this impossible. Good luck.

 
As mentioned, use contact cleaner. Spray it into the pot and turn it back and forth while doing so. Also... make SURE you disconnect the amp from power while doing so and leave it disconnected for about a minute after.

Another thing that works well for cleaning electronics is Simple Green. It does a great job but because it is water based, it takes a lot longer to dry than does contact cleaner, which is alcohol based.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
125
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
325
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
457
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
747
Amp
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
5
543

About this thread

conrow75

Junior Member
Thread starter
conrow75
Joined
Location
gowanda n.y
Start date
Participants
Who Replied
Replies
4
Views
965
Last reply date
Last reply from
conrow75
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top