RF T1001BD NOT 1 ohm stable???

[IamDeMan 5,000+ posts]

the sub section on my Power1000 runs @ 1ohm with no problems. It has for a while now. I don't see RF rating it for 1ohm if they couldn't do 1 ohm. You think they want to keep fixing amps under warranty? The shop is full of shit on that fact.

 

[Jdm94Coupe 10+ year member]

oo yea its no biggie 4 me to get it fixed the main reason i went there was for them to make a box for 2 15inch solobaric for my lil *** bmw.... it got done and im good with that.... now that its done i can and will do everything myself from now on..... i just gotta figure out how ima cut this **** 0 guage, lol..... i kno all about wiring and how to wire up subs so i dont really need them anymore....

i keep and keep asking this question.... are 1 channel amps with 2 pos/2 neg terminals wired in parrallel at the amp? should i wire my subs down to 2 ohm and wire them in there seperately? will it see 1 ohm still? if so i'd rather use all terminals and not have any unused....

 

[snoopdan 5,000+ posts]

i keep and keep asking this question.... are 1 channel amps with 2 pos/2 neg terminals wired in parrallel at the amp? should i wire my subs down to 2 ohm and wire them in there seperately? will it see 1 ohm still? if so i'd rather use all terminals and not have any unused....

yes they're in parallel on the motherboard and it will see 2 ohm if you have two 4 ohm circuits wired to the respecitve positive and negatives

 

[Jdm94Coupe 10+ year member]

so if i have them wired down to 2 ohm each speaker it then sees a 1 ohm load?