Recone question

[Anonymous 10+ year member]

What kind of pad do I need to get for my die grinder to get all the excess surround and spider off of the basket? I know it has probably been discussed but i could not find anything useful

Click to read more...

 

[thorshammer1 10+ year member]

don't know about a pad but I use a flat head screwdriver and a hammer. Then I use a dremel to grind the surround and spider landing smooth.

 

[NDMstang65 10+ year member]

36 grit flapper disc on a grinder

Use eye protection and a mask..CA glue is VERY VERY VERY bad for your lungs.

 

[snoopdan 5,000+ posts]

Could just use paint stripper gel from walmart. Its water soluable so you can just spray it off when you're done. Apparently im the only one who does this though //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

 

[rollerdj 10+ year member]

do you still have to put a lotta elbow grease into it, or is it pretty simple. I'm all for not using a grinder. The less chance I have of removing metal, the happier I am.

 

[snoopdan 5,000+ posts]

do you still have to put a lotta elbow grease into it, or is it pretty simple. I'm all for not using a grinder. The less chance I have of removing metal, the happier I am.

Very little actually. First you put alumnium duct tape over the coil gap. Then you just paint the stripper on and let it sit for a couple of hours, and the CA glue turns to jelly. Then you just gotta scrape it off a bit, I've even used just a towel. Then I take the baskets outside (even sometimes the motors too) and spay em off with a water hose, then let them dry. Only downside to this is that the paint on the basket will get sorta screwed up, but if your basket isnt painted to start with it doesnt matter. And if it is, oh well. Paint it again. besides if you would of grinded the shit off it still would of got scratched up anyways.

 

[Anonymous 10+ year member]

Thanks for the replys. I think I'm just going to grind it off