Reasons for hot amp?

[Justyn93 10+ year member]

Set my gains with a DDM to 44.7. My amp is a MRP-M1000 ALpine amp birth sheet says 1150RMS. 2 Type R's 2 ohm version, its wired to 2 ohms. i have o ga wire running to the back and no big three.

Click to read more...

 

[schackel 10+ year member]

1000 watts is hard to pull without big three

 

[Maxipads 10+ year member]

1. You already asked this question..

2. Its common for amps to heat up so what do you mean by "hot"

3. Whats your Bass Boost at?

Are you getting major voltage spikes?

And uhh I run 1400 with no big three?

 

[Justyn93 10+ year member]

I have NO bass boost on.

you can only hold your hand on for about 10 seconds.

it drops to about 12.9 or so....idk how major that is

 

[schackel 10+ year member]

1. You already asked this question..2. Its common for amps to heat up so what do you mean by "hot"

3. Whats your Bass Boost at?

Are you getting major voltage spikes?

And uhh I run 1400 with no big three?

oh ok i ran 2000 with it too. does not mean your not having problems

 

[Maxipads 10+ year member]

Are you sure on that 12.9?? thats a tad low..

 

[Maxipads 10+ year member]

oh ok i ran 2000 with it too. does not mean your not having problems

true true.. I only get bad drops when my roll my windows up or down... even with the subs on or off.. lulz but other than that i stay around 13.7-14.4 and 14.4 if im not idle

 

[Justyn93 10+ year member]

thats at the battery not the amp.... and its at idle

 

[Blasphemy 10+ year member]

I have NO bass boost on. you can only hold your hand on for about 10 seconds.

it drops to about 12.9 or so....idk how major that is

Ten seconds is kinda a long time. After about 20 minutes of playing I can only put my hand on my amp for about 2 seconds.

 

[Justyn93 10+ year member]

Will it damage the amp if it gets real hot. it has thermal protection so will that protect it

 

[Maxipads 10+ year member]

Yes... heat damages anything.. But thats why Alpine has those protecters but i wouldnt rely fully on those...

 

[Justyn93 10+ year member]

So think it will be fine? it only gets hot hot when i bump at full blast for about 10-15 mins

 

[kr15 5,000+ posts]

if it cant fry an egg dont worry

 

[Maxipads 10+ year member]

I don't know how hot it really is... but heats damages everything...Especially electronics.. try and pinpoint your problem.. Im willing to bet you have a shitty ground first of all....Are the center of the subs hot?

 

[grimreper912003 5,000+ posts]

Check your ground. Bad grounds can lead to hot amps.

 

[old_greg 10+ year member]

i had this amp. It likes to get hot. Just after awhile of good use it will get hot. Alpine amps mainly the V-power all get pretty hot

 

[old_greg 10+ year member]

1000 watts is hard to pull without big three

Im running 1300 with an AQ2200D with two DC lvl 3's

alot less harsh than the MRP-M1000

No dimming with the AQ.

I had a ton with the MRP-M1000

 

[Jaredturp 10+ year member]

I'm so tired of you Justyn. If your **** blows than you messed up! If not that it's all good! Turn it down or don't! It's a choice. Nobody here wants to listen to you ***** in the 3 threads you post every night about the same ****.

 

[old_greg 10+ year member]

I'm so tired of you Justyn. If your **** blows than you messed up! If not that it's all good! Turn it down or don't! It's a choice. Nobody here wants to listen to you ***** in the 3 threads you post every night about the same ****.

i like this guy

 

[SRim23 5,000+ posts]

like others have suggested, check your ground. if you think its good, it probably isn't. also, like everyone has said, amps get hot. thats just the nature of the beast. if your subs are getting hot (the cone) then im willing to bet you are pushing em too hard and clipping them.