Question about Mtx 1501d amplifier

[berettagtz 10+ year member]

I was wondering if this amp would work at 1.5 ohms.

Here are some more specs about it:

THUNDER1501D

• RMS Power measured at 12.5 Volts DC:

500 Watts x 1 into a 4 Ohm load with less than 2% Thd+N

1000 Watts x 1 into a 2 Ohm load with less than 2% Thd+N

• Dynamic Power measured at 14.4 Volts DC:

750 Watts x 1 into a 4 Ohm load

1500 Watts x 1 into a 2 Ohm load

• Signal to Noise Ratio: ≥100dB A-Weighted

• Damping Factor: >100

• Frequency Response: 20Hz-200Hz ± 3dB

• Maximum Input: 8Vrms

• Thunder EQ: Variable Bass Boost (0-18dB) centered at 40Hz

• Crossover: Variable 40Hz to 200Hz, 24dB/Octave Low Pass

• Dimensions: 17.8" x 9.75" x 2.1" (45.3cm x 24.8cm x 5.3cm)

Click to read more...

 

[tRiGgEr 5,000+ posts]

Yes and no. It will work but for how long. Also it will void your warranty.

I recommend against it. Your other option would be to get it modded...

 

[BassAddictJ 5,000+ posts]

i have amodded one running at 1 ohm and it runs fine, gets a lil warm but only gets HOT if i run it harder than hell for over 30 min.....solid amp. 1.5 ohms on a modded one will do just fine....

 

[chinny 5,000+ posts]

i read some were that it will do 1ohm out of the box

 

[iagrdshaka 5,000+ posts]

i read some were that it will do 1ohm out of the box

doubt it. probably just wishfull thinking