Protection Light!

87national

Junior Member
Hi, im trying to install some subs in my car and i have all the wiring from the trunk to the battery, radio, etc. The problem i have, is that i cant solve the red protection light on my amp. When the RCA's are plugged in, the red light comes on even though the ground isnt attached. When i connect the ground from that point the red light turns off but no green light (power) comes on. any help would be appreciated. I have trouble shooted a small bit by putting the remote wire into the 12V slot with the power cord and leading the other end into remote slot but with no avail. Thanks!

 
Try a different sources for audio input, and try to hook the remote wire straight from the 12 volt source and not to the remote off the radio.

 
Last edited by a moderator:
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

87national

Junior Member
Thread starter
87national
Joined
Location
minnesota
Start date
Participants
Who Replied
Replies
2
Views
544
Last reply date
Last reply from
10k-watts
20260126_101309.jpg

BP1Fanatic

    Jul 1, 2026
  • 0
  • 0
20260126_101257.jpg

BP1Fanatic

    Jul 1, 2026
  • 0
  • 0

New threads

Top