protect mode...

  • 2
    Participant count
  • Participant list

MemphisLove.
10+ year member

CarAudio.com Elite
589
0
PCB, Fl.
My memphis PR100.2 running my components goes into protect mode whenever i turn my pioneer 3800 past 42. it never use to do this... it started happeneing around 48 or so... very seldomly then it became more and more frequant now it does it all the time. my gains are a 1/3d of the way up. Is the ground loose or something???

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

As title. Once i get to about 4/5 max volume my JL HD600/4 amp goes into protection mode on 2 channels, powering my mids. The other 2 channels...
0
535
Pull it and test it at the battery post. Simple Power up test to verify if it powers up fine out of protect mode. if it does then Id be checking...
3
1K
Yeah i Yeah I know. I have my sub wired at 4ohm so I can get 300w rms from old amp. It’s 1000w max. And yes that’s the reason I got this pioneer...
40
4K
Your amp may have failed. A competent shop should be able to diagnose the issue in under 5 minutes either way. You didn't necessarily do...
6
2K

About this thread

MemphisLove.

10+ year member
CarAudio.com Elite
Thread starter
MemphisLove.
Joined
Location
PCB, Fl.
Start date
Participants
Who Replied
Replies
1
Views
478
Last reply date
Last reply from
luvinthebass
445981256_3731324230470906_9081536917273579948_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0
445387485_1610561083127261_6762343569694877677_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0

New threads

Top