price for deading

[redfish8]

how much would someone charge to deaden my 4 doors

Click to read more...

 

[redfish8]

bump

 

[Millertime1028 10+ year member]

You would save a huge amount of money if you did it yourself . Through a shop you are looking at around $600-$700 if you were to have them order the deadening and put it in .

 

[Thedeadly1 10+ year member]

i couldn't even imagine paying for that. Its so easy man its actually fun to do! try it

 

[audiobahnuser18 5,000+ posts]

shoot man just do it yourself. order fatmat , raammatt , second skin . i just got 50sq ft of fatmat $60 plus shipping but that's more then enough to do your doors. ok here's what u do

STEPS

1.) pull off the door panel most of the time there just plastic clips/poppers that u can pop out from the actual metal on the door . (CAUTION: Make sure that all screws are taken out first of the door panel)

2.) take out the speaker

3.) clean off the door panel if it has anything on it

4.) get yourself a wooden roller or rubber roller whichever

5.) take each sheet of deadner and slowly roll on the deadner to the door making sure that it is flat and sticking on the door fully

6.) make sure the door is done fully but do the inside of the door first i should of stated that first sry (making sure though the window can roll up and down with no problems.)

7.) put the speaker back in (make sure your connections on the speaker are still good not loose)

8.) put the door panel back in pop the poppers/clips back in

9.) put the screws back in the door

10.) test door panel make sure it's on there correctly

11.) give yourself a pat on the back because u just saved yourself a good amount of cash by doing it yourself.

need anymore help man just lmk. Good luck.

 

[Alpineforever 10+ year member]

What do you drive? Most door panels come off pretty easily and applying the deadener as easy as putting tape on a piece of paper... don't pay someone to do it. It's only a little time consuming but really easy, and no ones time should be worth that much money.

 

[redfish8]

its a f150 supercrew

one more question how do people seal the doors

 

[audiobahnuser18 5,000+ posts]

redfish what do u mean seal the doors. i mean there are many way's but no matter what air is always going to get out. but just do the inside of the door and the outer and you will be good like i had listed all those steps for you.

 

[Trey803 5,000+ posts]

Plexiglass and some kind of adhesive....there is a sticky about all of this you should read it

 

[Alpineforever 10+ year member]

Those F-150 panels use pop clips. To remove the door panels follow everything audiobahn user just said...

 

[Trey803 5,000+ posts]

my f150 has no clip. 3 screws and it lifts off

 

[WhoSayWho? 5,000+ posts]

And I personally would not do all four doors (then again I would not run speakers in the back either).

 

[audiobahnuser18 5,000+ posts]

Thx alpine i think i explained it pretty well . Im sure more people on here could add incase i did miss something.

 

[Trey803 5,000+ posts]

the screws are hidden and pieces must be removed to get to them though

 

[audiobahnuser18 5,000+ posts]

what yr f150 man?