Porting My Fi Qs

Chrispy
10+ year member

Senior VIP Member
The plan is to port 3 of my 4 Fi Q 15s. Only three because I want to be able to build the box outside of my car and still want room for my mids and highs which will also be in the wall. This will be my first ported setup so my question is how does 8.4ft @ 32hz with 110 inches of port area sound? I really dont want to go much bigger than that. Subs will be ran by a RF T4000 at 1.34 ohm. I'm currently running the 4 sealed in 8ft.

 
8.4 cubes is too small for three. I have one 15 inch Fi Q in just over 3 cubes and it sounds great but the lows aren't as loud as I expected. If I could I would have made the box 4 cubes at least just for the one. I think it would do a little better on the low lows.

 
How would the three ported in 8.4ft sound compared to 8ft sealed? What about a couple Xcon or BTLs 15s in 8.4 ft @ 32hz?

I'm thinking I would like more of an SPL sub. BTW I'll be running all pro audio mids/highs with this setup.

 
Cadillac Seville but I want to be able to build the box out of the car and a little over 11cuft is as big as I want to go. I came up with a design of 8.4cuft @ 32hz. I'm really starting to consider two BTL 15s if they're be louder in that box than 2 or 3 Qs would. Pretty sure the BTLs would be alot louder and make up for maybe not sounding as clean as the Qs.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

About this thread

Chrispy

10+ year member
Senior VIP Member
Thread starter
Chrispy
Joined
Location
Southern IL
Start date
Participants
Who Replied
Replies
8
Views
653
Last reply date
Last reply from
Chrispy
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top