Polk 330 amp best speaker wiring configuration??? Low RMS.

[bwc2210]

I am trying to figure out the best way to wire a single SVC sub (JL 10w0) to get the most watts out of the amp. At this time I have it bridged at 4 ohms. The problem I'm seeming to have is that it really seems to be bumping a lot less then I would imagine. I used a DMM to make sure it was getting proper power to the amp and everything seems to be good. I also did a RmS test with a DMM and a clamp meter. I used a 50hz test tone and I gathered that the amp was pushing around 143 watts. If the amp gain wasn't completely cranked I wouldn't be too worried about it.

Thank you in advance for your help.

Click to read more...