PG Rsd6.5 @ 2 Ohms.

[Gilliz 10+ year member]

I'll damage my ish yes? If I go Higher say 8, It'll be ok no?

Thx.

Click to read more...

 

[tcguy85 10+ year member]

what are you talking about?

 

[jblayz1 10+ year member]

hahahaha //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

 

[IonSQL 10+ year member]

ummm, yeah.......

 

[BASS_WARRIOR 10+ year member]

lol I was wondering the same thing

 

[dragnix 5,000+ posts]

wow...just wow

 

[IonSQL 10+ year member]

Whatever you do, just don't run them at 4 ohms, and you'll be fine... //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

 

[tcguy85 10+ year member]

run them at 0.5 ohms!

not sure how..... but make it work.

 

[Troydb 10+ year member]

you need four amps.. one for each speaker.

 

[Towncar 10+ year member]

hmm

 

[fwb_1234 10+ year member]

I'll damage my ish yes? If I go Higher say 8, It'll be ok no?
Thx.

Rewrite your question, ignore them, and then I'll try to help.

 

[mdillon 10+ year member]

I'll damage my ish yes? If I go Higher say 8, It'll be ok no?

translated to:

if i run my components at 2 ohms will i damage them? but if i run them higher, up to 8 ohms will they still run fine?

i hope im right....

 

[IonSQL 10+ year member]

Yeah, I think we knew what me meant.... doesn't change anything

 

[Etac 10+ year member]

the speaker doesnt care what resistance it has...if you wired a pair down to 2 ohms (which is the only way i see how) it should be fine as long as your amp can handle it and you dont put too much power into them.. but if you're wiring one set down to 2 ohms.. dont forget it will be mono..

 

[J31Rob 5,000+ posts]

I'll damage my ish yes? If I go Higher say 8, It'll be ok no?
Thx.

Only difference is more/less power, 2 ohm = more, 8 ohm = less.

Rewrite your question, ignore them, and then I'll try to help.

Yeah, some people just can't use common sense to make sense of an apparently miswritten statement.

I'll damage my ish yes? If I go Higher say 8, It'll be ok no?
translated to:

if i run my components at 2 ohms will i damage them? but if i run them higher, up to 8 ohms will they still run fine?

i hope im right....

Refer to my first reply.