Passive crossover points for RSD 65cs

  • 2
    Participant count
  • Participant list
nobody knows. i was told by PG that the FS of the tweeter is between 1200 and 1500. and was suggested by them to use between 2500hz and 3000hz for my crossover points. not sure if i'd use to much power with them crossed THAT low though. i have used 3.15k and 4k will the power i have w/o any issues though.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yep. It would be a little over 3 wired in series, but that’s fine.
3
829
Agreed. I was actually thinking of building a 3-way passive and I compared the cost to a Dayton DSP and it makes no sense to go passive.
10
2K
Also if you did decide to get another amp the output rca on the amp can be adjusted with the internal dsp
6
2K
You're not trying to figure out the mass of air in your 3" port or whatever, you're trying to figure out the mass of air that you would need in an...
12
2K
well they list that frequence response so I will try to use it. Also, does it help to have the marine speakers in their towers for such a thing...
2
773

About this thread

ronjon228

10+ year member
Senior VIP Member
Thread starter
ronjon228
Joined
Location
Michigan
Start date
Participants
Who Replied
Replies
1
Views
826
Last reply date
Last reply from
tcguy85
20240518_170822.jpg

Dylan27

    May 18, 2024
  • 0
  • 0
20240517_190901.jpg

Dylan27

    May 18, 2024
  • 0
  • 0

New threads

Top