F Ffej Member 38 0 Wichita, KS Jan 23, 2017 #1 Wiring up 2 2ohm DVC subs to a mono amp. Want to run at 2ohms, but when I check with my DMM, I'm getting 2.3ohms. Did I do something wrong? Thanks, Jeff Click to read more...
Wiring up 2 2ohm DVC subs to a mono amp. Want to run at 2ohms, but when I check with my DMM, I'm getting 2.3ohms. Did I do something wrong? Thanks, Jeff Click to read more...
J jijivs Junior Member 5 0 Bangalore Jan 23, 2017 #2 Usual dmm won't be accurate at low values. I observed dmm always have offset. Just short the dmm cable terminal and see the value. This offset value to be reduced from the ohms you got for speaker. Overall nothing to worry. Its the dmm error! Drive safe, JVS
Usual dmm won't be accurate at low values. I observed dmm always have offset. Just short the dmm cable terminal and see the value. This offset value to be reduced from the ohms you got for speaker. Overall nothing to worry. Its the dmm error! Drive safe, JVS
shizzzon 10+ year member I am who you think I am 1,294 0 KY Jan 23, 2017 #3 your final reading should be the same as a single coil