NINe5 came in: (pics of interals)

[Megalomaniac 5,000+ posts]

1/0 awg and new speaker wire comes in today woot.

 

[na_rsx 10+ year member]

i plan to clamp the amp for myself too. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

please do so, if it at least puts out over 800rms, then my FI Q should be nice and dandy, because i am **** sure 600rms wont do shit //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

 

[Megalomaniac 5,000+ posts]

my pron was better it showed nudez

 

[na_rsx 10+ year member]

no fusing at the amp?

of course, a (3) 40A fuses

my pron was better it showed nudez

touche, btw i have 0 gauge going directly into the Nine.5, kicker hyperflex too. also have 8 gauge kicker going to the sub. and 16 gauge kicker for my components w00t. also kicker rca's.

all kicker baby,

 

[dragnix 5,000+ posts]

of course, a (3) 40A fuses

ahh..did not see that in the pix

 

[ItalynStylion 10+ year member]

I'm running 4 gauge left over from what was powering my PPI 600.4

I should probably remedy that in the near future once I use the rear two channels too.

 

[na_rsx 10+ year member]

ahh..did not see that in the pix

yeah, so i just picked up knukonceptz 0 gauge anl fuse holders with 120A fuses, to do the big 3 and fuse the battery in back. i hope to get at least 800rms+ ray:

 

[nbudros 10+ year member]

Your shoes are ghey.

WRONG! FAIL

 

[Megalomaniac 5,000+ posts]

im just going to use a 200a fuse anl

 

[na_rsx 10+ year member]

bump for a kick *** amp

 

[Megalomaniac 5,000+ posts]

lol. aight

well today im going to install it, even though the new 1/0awg didnt come in yet. Im sure my 2awg is fine and 1/0awg ground. I will post pictures later on. I will probably retune the car again today with the added power.

 

[Megalomaniac 5,000+ posts]

here is my current(well current layout, cause the sub dustcap has been changed since then) setup

here is my amp rack for that underneith

looks i will have to take all that off, and put amp right on top and run the 2awg straight in.

 

[ItalynStylion 10+ year member]

Looks like the ED should fit in there just fine if that Zapco was in there before. Plus, you will gain the extra space from the other amp not being in there too.

 

[Megalomaniac 5,000+ posts]

OK the amp is installed. this amp is a current hog, my lights dim/flicker on idle. and the Bass KNob does not work for sh!t. Steven, can i borrow yours and see if it is a knob problem?

yes i did switch the remote ON on amp.

 

[dragnix 5,000+ posts]

//content.invisioncic.com/y282845/emoticons/woot.gif.aaa6090e619a97b6090d16dd863c5a69.gif typical eD

//content.invisioncic.com/y282845/emoticons/tongue.gif.6130eb82179565f6db8d26d6001dcd24.gif