SOLD *new 2 Channel Amp*

  • 3
    Participant count
  • Participant list

barto
10+ year member

Member
USX amp model # 4065 AWSOME AMP

Amplifier Type: Multi-Channel

RMS Power: 65W x 4 @ 12.9V

Bridged RMS Power: 160W x 2 @ 12.9V

THD at Rated RMS Power:

Speaker Level Inputs: No

Preamp Outputs: Yes

Built-In Crossovers: HP/LP

Frequency Response: 10-30,000 Hz

Channel Separation: 80 dB

Signal to Noise Ratio: 100 dB

thats the specs ummmm

it is new

never used never even taken out of plastic!!!

make an offer

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
146
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
377
Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
756
It is Opel (Vauxhall) Astra J 2011 model, I change the HU to Kirinavi 10 inch screen. The factory speakers are Infinity and would have come with a...
3
837
Okay, I'll bite. If you're going to get rear speakers, get the same ones (model type, doesn't have to be the same size) that you have up front...
1
1K

About this thread

barto

10+ year member
Member
Thread starter
barto
Joined
Location
Pittsburgh, PA
Start date
Participants
Who Replied
Replies
8
Views
532
Last reply date
Last reply from
barto
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top