Needing help

[Techydrone]

Alright I'm tired of trying to figure this out and understand this on my own. It's been eating me up all day. I'm wanting to get two psi platform 3 15s. Ok. They have a dual 1 ohm (0.7 DC) dual 1 ohm (1.0dc) dual 2 ohm (1.4 DC) and a dual 2 ohm (2.0 DC) ok are you following me. I'm wanting to get a taramps 8k. Alright. They offer a 2 ohm and a 1 ohm. Now the 1 ohm is far better. If I wanted to get the 1 ohm, What speaker selection should I make, and how should I wire them, And is it possible. Sounds simple, I feel dumb.

Click to read more...

 

[BOOMINGRANDPA 5,000+ posts]

d2 wire to 1 or 4 ohm, so u be at .5 ohm if u wire to 1 ohm each.. 1.4 ohm wire to .7 or 2.8ohm so 2 would be .35 or 1.4ohm (not bad but depends what amp does there and power u want).. d1 is .5ohm or 2 ohm each so u could get 1 ohm outta that.. see what popwar says he had that amp i think maybe those subs better to be at 1.4ohm on that amp depends on power u want or how hard u want to drive the amp..

 

[Popwarhomie 5,000+ posts]

I told you that you want the dual 1s in your other thread you made. Not dual 0.7s.

They offer a 2 ohm and a 1 ohm. Now the 1 ohm is far better.

The 1ohm and 2 ohm are the same. Just make the power at 1 ohm or 2ohms.

 

[Techydrone]

Wouldn't that ultimately end up at .5 ohm no matter how you wire it?

 

[Techydrone]

Oh wait. 1 ohm In series would be 2 + another 2 put together is 1..... Ohm. I think I cracked it I'm so slow

 

[Popwarhomie 5,000+ posts]

https://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=12#results

 

[Techydrone]

Thank you