ya as title says; i gotta figure out if the at1000 i just got in a trade is fried or if i am.
Amp is an Autotek AT1000 wired to an Version 1 IDQ 12'' d4 which is currently wired like this but bridged
http://a248.e.akamai.net/pix.crutchf...4-ohm_mono.jpg
Amp starts up fine and sub sounds good; for about 20-45 min; then amp gets REALLY hot and goes in to protect.
I have checked and rechecked and rechecked my power/ground which were the same as my previous WORKING system.
Ive tried several different coil configs with the same responce. At this point i just want to send the amps from trade back and get my subs, just wanna make sure amp is fried b4 i do.
