need some info...bridging a JL 300/4

[Smoknum 10+ year member]

I am a little confused on how to bridge this amp. The manual is a little hard to understand. I currently have one set of components run to the rear channels bridged and the other bridged to the front channels. Set to 2 channel mode. I have a set of rcas coming off of the front output of the deck going to the front channel rcas. It plays fine like this but I dont think its right. The manual says something about using a splitter, I guess this is where Im getting confused.

On a side note I have the High Pass set to 75hz on the front and rear channels. The thing is I was setting my gains on my sub amp with a 50hz tone and the mids are still playing. I dont know whats up with that. My deck is an Eclipse 8053 and I have the crossovers turned off so the amp should be taking care of it.

Any help or suggestions would be great. A picture would be awesome.

Thanks

Chuck

Click to read more...

 

[azbass 5,000+ posts]

keep your amp set on 2chan mode, all it does is take the "front input" signal and feed it internaly to the "rear inputs" so you dont need splitters/rcas plugged in to the rear input.

 

[chucku 10+ year member]

Im confused, if you bridge a 300/4, which I have , you get 2 channels, left and right. Did you hook up 4 speakers to the bridged channels?//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif Ive hooked this amp up every way (or at least I thougt). I finally ran my comps active and couldnt be happier.