need some help for a repair on a viper

[xchaosx 10+ year member]

the rca plug on my 1200 are shot where can i find a replacement and any advice would help also

Click to read more...

 

[LoudCrownVic 5,000+ posts]

Uhh... What?

Those look fine... Did they break off and fall in?

YOu could solder on some female rca's on a wire and have it hang out like on a HU...

 

[PhatTonyDeMarco 5,000+ posts]

That is not an actual picture of his amp....

 

[xchaosx 10+ year member]

lol no that's not the pic of my amp just to use for a ref yea the internals are rattles loose i think i have it apart and all the solder is solid if i move the rcas around it will cut in and out it will work for a bit untill i start to hit hard or hit a bump

 

[Blazin_Jason 10+ year member]

Sounds like a cold solder joint then. Heat up the areas where the rcas are soldered to the board, let it flow and if need be add a little more solder.

 

[xchaosx 10+ year member]

even if the joints look perfect with no cracks or breaks at all hell i'll try anything once but just makeing sure we are on the same page

 

[Blazin_Jason 10+ year member]

That's what I would do.