Need opinions on a brad nailer

[ramos 5,000+ posts]

BJ
those harbor freight bits arent even straight. I had the guide from a FLush trim fly off after about 30 seconds.

I have two sets of the router bits ( lifetime carbide or some crap ) Never had a problem with any of them. Been using them for going on fiver years now. Only reason I bought the second set was some of the first set are getting dull . Can't stand the power tools they sell as most are junk , they have some decent air tools . //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[DBfan187 5,000+ posts]

I have that same gun in that link, don't get it unless you're near an outlet as it uses a ton of current!!!

On another note I reccomend brad nailers because you can finish a box in under an hour.//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[ramos 5,000+ posts]

I have that same gun in that link, don't get it unless you're near an outlet as it uses a ton of current!!!

On another note I recommend brad nailer's because you can finish a box in under an hour.//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Pfffttt.... , I know a couple people that can go from 1 flat peice of mdf to a predrilled , countersunk, enclosure in under a hour half an hour . That's counting toting the table saw down the hill too . //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[DBfan187 5,000+ posts]

some of us like to have many beer breaks.//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[baseballer1100 5,000+ posts]

I think the brad nailer is a lot more fun to use.

 

[ramos 5,000+ posts]

some of us like to have many beer breaks.//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Fear Of the oompha pimp showing up and laying the smack down upon us , and Loyd's a slave driver //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[BaseSteala112 10+ year member]

No problems with my Dewalt....

 

[Benilson09 10+ year member]

Electric... not sure. But I have a pnuematic Hitachi brad nailer, and it's GREAT! I highly recommend it.
nG

Is there a particualr model that you are using??