need help trying hook up two 12' subwoofers to a 2 channel amp down to 1 channel

[Phoenix Risen 10+ year member]

u would connect the speaker wires together then runn one set of wires to the amp.

and if they are infact single 4 then he will watch his amp go into protect everytime he tries to turn it up or he will be getting the magic smoke out of the subs for putting to much power to them.

 

[paulwall 10+ year member]

ight my bad i'm doing dat ryt now..i never had 2 **** wit dis **** before i'm just used to 2 or 4 channel ..just never went to a 1 channel before dat;s all

 

[Phoenix Risen 10+ year member]

once you have the vc config well tell you how to wire it.

 

[paulwall 10+ year member]

yeah they are 8 ohm srry bout all dis shittt..never had 2 do all dis..**** just confuses da fuuuck out of me.....fuuckk it den i will run it 1 channel if da shitt burns up den his loss my gain...so i'm going 2 run one wire from da amp 2 da connecters..

 

[Vossy 10+ year member]

If they're 8 ohm then you can bridge them, just take both positives and put it in the farthest left positive, and both negatives to the farthest right negative.

 

[paulwall 10+ year member]

kk so it's like running a capacitor

 

[paulwall 10+ year member]

well no smoke yet...there on ...so far so good

 

[disturbed471985 5,000+ posts]

u would wire like this - http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=81

 

[paulwall 10+ year member]

thx 4 da help....next tyme i hope it's easier..well least i learned something