need help on knukonceptz dist block? im stumped!

[SPL140.2 5,000+ posts]

This is the distribution block im putting in my g/f car its made by knukonceptz http://www.knukonceptz.com/assets/productImages/BC-1024B.JPG I have never seen this kind of block with out something to secure the wire to it. You have to unscrew the ring and put the wire in but it wont stay secure. ive tried turning the wire but doesnt help. The only thing i can think of is putting the wire in and folding some of the outer strands around the ring and screw it back on, anyone have a clue?

Click to read more...

 

[johnecon2001 5,000+ posts]

there should have been some kind of rubber gasket inside to create a friction to hold the wire in. If your sick of D1cking around with that one, I can hook you up with an easier one.

 

[Slody4Futbol 10+ year member]

it's a kompression block... you unscrew the thing... put your wire in... and fold the edges of the wire back around the edge of the ring... and push it in and screw it back... that's how it works.... took me FOREVER to figure out and then my boss showed me lol

 

[SPL140.2 5,000+ posts]

it's a kompression block... you unscrew the thing... put your wire in... and fold the edges of the wire back around the edge of the ring... and push it in and screw it back... that's how it works.... took me FOREVER to figure out and then my boss showed me lol

Thats what I did finally, i wasnt 100% sure though, i spent like 2 hours trying to figure that stupid thing out lol. Works good and looks sharp though.