Need Help Finding Amp Kit

[ddog003]

Hey, I just got 2 Infinity Kappa Perfect 10.1d subs and an Infinity Reference 611a amp to power them. I was just wondering what would be the ideal amp kit for this and if anyone knows where to get one for a good price. I am also a bit condused on how I should wire my subs to my amp. Is this amp good for these subs? Here are the specs below. Thx.

Each Sub

Size: 10 inch

Rec. Sealed Box Dims: .6 - .6 cu.ft.

Rec. Ported Box Dims: 1 - 1 cu.ft

Free Air Usage: not recommended

Sensitivity: 94 dB

Frequency Response: 18-150 Hz

Recommended RMS Power: 350W

Peak Power Handling: 1400W

Impedance: dual 4 ohms subwoofer wiring options

Amp

Amplifier Type: Mono

RMS Power: 456W x 1 @ 4 ohms

THD at 4-Ohm RMS Power:

Bridged RMS Power: 657W x 1 @ 2 ohms

Speaker Level Inputs: no

Preamp Outputs : yes

Built-In Crossovers: LP

Bass Boost: 0 - 12 dB

Frequency Response: 17-302 Hz

Signal to Noise Ratio: 70 dB

Fuse Rating: 2 x 30 amps

Click to read more...

 

[crow 10+ year member]

Ideally, you would want two dual 2 ohm subs so you could wire them to a final 2 ohm load on the amp getting 657 watts to the subs. You can wire two dual 4 ohm subs to a final 4 ohm load or a final 1 ohm load. I'm not sure that your amp will be stable running a 1 ohm load. Some amps are but many are not. If you wire the subs to a final 4 ohm load you will get 456 watts from the amp. It will work but it isn't the most efficient setup.

Here's a link to some sub wiring diagrams. Select your setup on the pulldown menu.

http://www.infinitysystems.com/caraudio/sub_wiring.aspx

 

[crow 10+ year member]

Hmmm...

Apparently the Infinity link does not believe in dual 2 ohm subwoofers. Here's a better one...

http://mobile.jlaudio.com/support_pages.php?page_id=161