need amp for alpine type s 600c (help)

[sciullo779 10+ year member]

ok i dont know what power rating im looking at, i understand rms and peak, but the box says the 2 speakers connected properly have an input impedance of 4 ohm, so does that mean i look for the amps rms rating @ 4ohm or what? because i read that when you put speakers in a parallel their resistance divides, so wouldnt it be like 2 ohm if both speakers are 4 ohm?

idk, they both take power at the midrange so, the filter and tweet is wired to the terminals on the midrange

i need to know by 3pm est, any help is appreciated

http://akamaipix.crutchfield.com/Manuals/500/500SPS600C.PDF link to manual i think the pic of the connections is on the right

Click to read more...

 

[sciullo779 10+ year member]

bumpity bump bump

 

[gunz4me 10+ year member]

You need an amp that delivers between 50 and 100 watts per channel @ 4 ohms to make those babies sing //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

Disregard the ohm load of the tweeter because it is connected through a passive crossover network that was designed to deliver a final 4 ohm nominal load with the woofer and tweeter connected to it. I hope this makes sense because I have to run for now.

 

[michaellane 5,000+ posts]

just buy a 4channel amp and you will be fine. it will power these and your rear speakers

 

[sciullo779 10+ year member]

just got a 4 channel 400w rms amp using the front 2 for components and the second set for a 10 in a box,