need a ported box for 2 comp 12"s

[Twistid 5,000+ posts]

anyone!?

 

[Silver 10+ year member]

A, B, and C are just labeling the sides of the box...

Just multiply the front/rear and top/bottom by two, then divide them with a piece of MDF (divider). Then do the ports.

3/4 MDF

Liquid Nails

Drywall screws (i used 2") little long but will do the job fine.

Thats it. Your making this harder than ya think.

PS: DO NOT get your boards cut at **** Depot. All of mine were off my 1/4 of an inch. I had to re cut everything to fit. Have fun!

 

[Twistid 5,000+ posts]

couldent i just build the two sepearte boxes then attach them together?

 

[slicks5150 10+ year member]

not a good Idea and would be alot more work just build 1 box and be done with it!

THATS ALL!

 

[Twistid 5,000+ posts]

ok i understand that but i still dont know how to, you said double it or something but i still dont get it, you would have to draw it out (which i actually would appreciate) it would only take like 5 minutes in paint shop with the plans i already posted...

 

[kuijo 10+ year member]

make sure it can fit wherever u putting it before u start making it.

 

[slicks5150 10+ year member]

heres the plans they gave me

so what would you guys do with them? could you photoshop them to what you all were sayin then repost them plz? also if you could post the meaning of "A" and "C" ??? theres arrows that point to spots and there labeled A and C

thanks

that cut list makes no sense.

 

[Twistid 5,000+ posts]

why does the cutlist make no sence? it came off kickers website so.....

 

[slicks5150 10+ year member]

look at it. it says the top and bottom are 14.25" high and 14" deep.

and the side panels it says are 14.25" high and 25 7/8 deep

well than the top and bottom would have to be 14.25" high and depending on how the box is built ( with the sides on top of the bottom or butted up against the bottom than the measurement would vary by 3/4 ". ) some where around 25 7/8" deep as well is what the top and bottom should be.

Am I looking at it wrong ? //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif I do have a slight buzz going. .. .

someone correct me if I'm wrong.